This valve has a normal right hand thread and you can insert and remove this type of valve with a spanner.

No thread tape is necessary to fit this valve.  This valve is the o-ring type so the o-ring already included on the valve will seal against the face of the cylinder neck.

The cylinder valve has integrated 250bar burst disk and self closing pin to shut off the flow of gas.

If you need a replacement o-ring for this valve the part number is KL13994

NOTE: To correctly install this valve we recommend a valve tighness of 85-90Nm

Please Note:
All fittings must be changed over by a trained professional, misuse of this product is not covered under warranty. Failure to do so could cause serious injury.